Simms injection pump. Ford 7700 1976 .. Not getting fuel out of top of pump for #2 cylinder suspect some trash got through.. the other 3 have fuel.. but tractor won't fire now. It started right up after sitting for 2 weeks but throttle and shut off didn't affect it.
Ford Power Stroke 6.7L Fuel Injector Puller And Seat Repair Service Kit - Robby. from $19.95. ProMAXX Tool’s NEW Ford Power Stroke 6.7L Fuel Injector Service Kit allows technicians to quickly pop stubborn fuel injectors then restore the injector seat to factory-new condition in about 15 seconds.
6.0 Powerstroke - INJECTOR Replacement. Stuck Open Injector. Smoking at Idle fix. So this is the fix to the video I did on figuring out if your injectors are
You can clearly see the pink washer fluid residue on the casting cavity around the injector . A simple injector replacement became a major undertaking as the washer fluid, which is corrosive fused the injector into the cylinder head. You can compare the broken partitions at front to the new ones in the box, it’s actually made out of 3 pieces.

Quick video of a 4-71 with a sticky injector. The customer was complaining of the engine not shutting down.Replaced the injector and adjusted the top set.The

The average fuel injector replacement cost is between $100 and $500, depending on the car model and labor costs. A fuel injector usually costs between $50 and $300. Labor usually costs between $50 and 200$. The fuel injector’s cost may differ a lot depending on if you have a gas or diesel engine.
The seller told me that the tractor "needs a new injection pump", but he did not tell me exactly what was wrong with it. I dragged the tractor home and started experimenting. I drained the old diesel fuel out of the tank and replaced it with fresh fuel. I used the hand primer pump on the side of the block to bring fuel to the injection pump. Soot in the fuel system. Injector seats erode away. If you pull the injector out, you might also see discoloration or carbon tracking on the tip of the injector. That's a telltale sign that the injector isn't sealing properly with the cylinder head. Because of this, air gets into the fuel and the air is compressed instead of the fuel. EASY TO USE: To use, first attach the tool to the injector you wish to remove, then yank the weight towards the handle to give an extra snap of weight to the stuck part; The force transfers to the shaft, pulling the attached end and injector in the desired direction; Repeat action until the part is removed; Always work with a cold engine to avoid damage and remember to replace all injectors as c7Tj.
  • mzpr041jr1.pages.dev/345
  • mzpr041jr1.pages.dev/37
  • mzpr041jr1.pages.dev/443
  • mzpr041jr1.pages.dev/208
  • mzpr041jr1.pages.dev/257
  • mzpr041jr1.pages.dev/429
  • mzpr041jr1.pages.dev/352
  • mzpr041jr1.pages.dev/211

    • how to remove stuck diesel fuel injector